Mikomer Decorative Window Film,Black Flower Static Cling Privacy Door Film, Non Adhesive Heat Control Anti UV Window Cling for Office and Home,17.5 inches by 78.7 inches
From the brand
Product Description
|
|
|
|
|---|---|---|
No Glue,Resuable and Easy Application
|
Privacy,Light and Decoration
|
No More Broken Blinds and Noisy Pets
|
Small Tips
- Don't forget to remove transparent backing before putting on glass.
- Only used on Smooth Glass Surfaces.Don't apply to outside window or window with crack or dust.
- Please use a hair dryer to soften the film before applying under cold weather (Heat Resistant up to 176℉)
How to install Mikomer window film?
How to install Mikomer window film?
1 roll window film
1 copy installation instruction
- Step 1 Clean your window thoroughly and make sure the surface is clean and smooth enough.
- Step 2 Measure length and width of the window and cut the window film with a proper size. Leave an extra inch margin each side for an easy adjustment.
- Step 3 Completely spray water or soap-suds on the window.The more water will help to stick.
- Step 4 Peel off the clear backing film of the window film.
- Step 5 Stick the film to the window and use your hand to press it to attach to the window surface tightly.
- Step 6 Use the cleaning cloth or squeegee to wipe the film back and forth to make sure that the bubbles and water have been totally removed.
- Step 7 Trim off the margins and use a cloth to flatten out the film.
Questions & Answers
Q1:Window film can’t stick to the window
A: The window glass is not smooth enough/The window didn’t wet/The transparent backing film didn’t be removed.
S: Stick to smooth glass surface/Wet the window with water or soap-suds /Remove the transparent backing film.
Q2: It is difficult to remove the backing film
A:Take two pieces of tape and place them on opposite sides of the same corner.Pull the tape apart,the film and the backing should separate from each other easily.
Q3:The window film can’t stick although the backing film was removed and the window was wet
A: Applied the wrong side/Excessive water or bubbles remained
S:Tear it off and retry the smooth side to stick/Scrape excessive water and bubbles.
Q4: There are a large number of small bubbles.
A: Too less water/Too many dust.
S: Tear it down,clean the window thoroughly,spray plenty water,stick it again and scrape all bubbles.
Q5: The edge of window film begins to fell off
A: The edge of film is too close to the window.
S: Tear it off and stick again after heating the edge of the window film with a hair dryer, at the same time, reserve a 2-3 mm interval between the window film and window frames.
|
|
|
|
|
|
|
|---|---|---|---|---|---|---|
| Tulip Window Film | Frosted Window Film | Blind Window Film | Bamboo Window Film | Geometric Window Film | Wheat Flower Window Film | |
| Privacy Level | Low | High | High | Low | High | Semi-Privacy |
| Can Pattern Ally Together? | NO | YES | NO | NO | NO | NO |