Submitted by ninian1927 t3_11azplu in DIY
ninian1927 OP t1_j9w5rqf wrote
Reply to comment by knowitallz in Ducting for under cabinet range hood, how to offset to get by stud? by ninian1927
It's a load bearing exterior wall so I'm not sure, beyond my comfort level really. I guess my question is, would only using two 45s still allow me to offset a few inches to the left and then out? That's the part confusing me, the duct cutout in the hood is directly in middle of it ( on top), so I need to start there with duct, go left a few inches, and then connect to the exterior wall vent duct which will be likely at top (inside) of cabinet
knowitallz t1_j9w6qc1 wrote
Then go left with two 45s and go out. 45 is just a less of a quick turn. Less noise by a lot. I have a straight shot with 8 inch pipe straight up and run a 900 cfm fan that has 4 settings. I cant hardly hear it at full blast
Viewing a single comment thread. View all comments