Viewing a single comment thread. View all comments

Maleficent_Guard_462 t1_iuh7mca wrote

really you need to take that to pieces and put the stab back together and solder it back up again. but - if you're a real maverick you can do it with tweezers and brute force but it involves pushing the wire out under the plate until you basically can't see it and it's a real muck about. only two options really.

1

Jadenexe OP t1_iuh7smc wrote

So i basically I push it back in with force?

1

Maleficent_Guard_462 t1_iuhajfn wrote

well if you're going to do it that way - with tweezers, you need to push that bit of stab wire up and out the way so you can get the little bit back in - but you need to put the stab in so that the wire goes in the middle - so it's a bit of a muck about and quite difficult, but it is possible. but if you don't know what you're trying to do you may just break it completely. the best / least risk way would be to desolder the board entirely and fix it and then put it back together - but if you are not experienced desoldering can sometimes break everything entirely too! if you're UK I can fix this for you.

0