Yak54RC

Yak54RC OP t1_j2f85ju wrote

If you are building new and you have a massive house then I can see justifying the extra cost and complexity. The more I read and learn about air source heat pump the less appealing ground source looks. The efficiency percent of air source heat pumps already is good enough to make it financially viable. You just have to do the math and see if the payback different between ground source and air source makes sense.

2

Yak54RC OP t1_j2efd99 wrote

The Bosch air handler has dip switches inside to change the fan speed. The unit I have is very similar to the Bosch. You can have a look at this manual to familiarize yourself https://resource.bakerdist.com/is/content/Watscocom/Gemaire/bosch_8-733-952-441_article_2674327384527413_en_ii.pdf

The issue I have with some installers if that they won’t spend the time to set up each system to each home. Most will just install and not set settings for comfort or efficiency.

3

Yak54RC OP t1_j2e4w1b wrote

What water heater you have and what heat pump. On the coldest day this month my heat pump used 32 kwhr. You might have heat strips as auxiliary heating. Newer heat pumps like the one I have don’t need backup heat. I also have heat pump water heater which uses 3-5 kwhr per day in winter

3

Yak54RC OP t1_j2dz3lp wrote

yes i would love to just give my small amount of info to someone that might have heard different or might not even know they are an option in the state . i have gas backup since i kept original furnace as air handler but i have not used any gas so far and not planning to use it at all

6

Yak54RC OP t1_j2dypii wrote

yes i installed it myself but i had also previosuly installed the AC about 4 years back (which i did A TON of research for ) so i had the knowledge and tools . you just need to find a goof company or person that will work with you. it is up to us to do due diligence and get multiple quotes. I undertsnad the hesitation of homeowners with no info and of HVAC technicans that have not worked on these systems before.

5

Yak54RC OP t1_j2dxx6s wrote

you need to remember that these units are all good units BUT if you have a bad installation or bad sizing with no information then they wont work right. just make sure its PROPERLY installed and that the unit you buy is the correct for the use you need. i understand the allure of those precharged lines but i have hear a lot of bad things. my unit was properly vacuumed and charged to EXACT amount of refrigerant per manufacturer. this is VERY important with these types of heat pumps

4

Yak54RC t1_iyhk68a wrote

I’m non union electrician but I would tell anyone starting out to EXHAUST the union route before jumping into a non union trade. Unions like everything else have their negatives (idk many) but for people starting out it’s the way to go or else you will go through some shitty experiences of being taken advantage of and not knowing how to navigate through all the bullshit. The longer I’m in the trades the more I see the importance of having a collective in charge of advocating for the whole of the workers. If I was to start over I would have gone the union route first.

22