nevets429 t1_jebbw9f wrote on March 30, 2023 at 7:43 PM Reply to Screw length in a table top by tonitacker General rule for most surfaces in woodworking is not to exceed 2/3 the thickness. I’ve had some particle boards that anything more than half the thickness shows a dimple on the backside. I’d go slow and add a few washers if necessary. Permalink 3
nevets429 t1_j69zraz wrote on January 28, 2023 at 8:45 PM Reply to Electrical help by Mental_Section_5505 No photos attached. Permalink 1
nevets429 t1_jebbw9f wrote
Reply to Screw length in a table top by tonitacker
General rule for most surfaces in woodworking is not to exceed 2/3 the thickness. I’ve had some particle boards that anything more than half the thickness shows a dimple on the backside. I’d go slow and add a few washers if necessary.